CHARON-AXP for Windows configuration details
- Copy Page Tree
- Bruno Miretti (Deactivated)
- Kirill Nikolaev (Unlicensed)
Introduction
This chapter describes, in detail, the configuration parameters of the devices emulated by CHARON-AXP for Windows, with corresponding examples and parameters.
The emulated devices are loaded with the "load" command (if a device has not been already loaded) and the parameters are made active with the "set" command. These parameters can be specified directly in the "load" command.
Example:
|
In this example, an instance of a KZPBA controller is loaded with the name "DKA". Its first unit, "container[0]", is mapped to the "C:\Charon\Disks\BootDisk.vdisk" disk image.
The Controller name is accompanied with a "/<module name>". The module name is a CHARON-AXP component that specifies the controller load module. Its name can be the same as the loaded controller, however this is not mandatory. Once a module name is specified, there is no need to specify it again for additional references of the same controller.
Details of CHARON-AXP configuration
- General Settings
- Core Devices
- Console
- Remote Management Console (RMC)
- Placement of peripheral devices on PCI bus
- Disks and tapes
- Networking
- DEFPA PCI FDDI adapter
- PBXDA-xx series PCI serial adapters
- PBXGA graphics card
- Sample configuration files
© Stromasys, 1999-2024 - All the information is provided on the best effort basis, and might be changed anytime without notice. Information provided does not mean Stromasys commitment to any features described.