CHARON-AXP for Windows configuration details
Introduction
This chapter describes, in detail, the configuration parameters of the devices emulated by CHARON-AXP for Windows, with corresponding examples and parameters.
The emulated devices are loaded with the "load" command (if a device has not been already loaded) and the parameters are made active with the "set" command. These parameters can be specified directly in the "load" command.
Example:
|
In this example, an instance of a KZPBA controller is loaded with the name "DKA". Its first unit, "container[0]", is mapped to the "C:\Charon\Disks\BootDisk.vdisk" disk image.
The Controller name is accompanied with a "/<module name>". The module name is a CHARON-AXP component that specifies the controller load module. Its name can be the same as the loaded controller, however this is not mandatory. Once a module name is specified, there is no need to specify it again for additional references of the same controller.
Details of CHARON-AXP configuration
- General Settings
- Core Devices
- Console
- Placement of peripheral devices on PCI bus
- Disks and tapes
- Networking
- DEFPA PCI FDDI adapter
- PBXDA-xx series PCI serial adapters
- Sample configuration files
© Stromasys, 1999-2025 - All the information is provided on the best effort basis, and might be changed anytime without notice. Information provided does not mean Stromasys commitment to any features described.
Need fast, reliable migration? We have done it countless times. Talk to an expert