The license update utility (HASPRUS) looks the same, independent of the product variant used.

The following image shows the necessary options for creating a fingerprint file: select the tab Collect Status Information and the option Installation of new protection key.

After pressing the Collect Information button, you will be prompted to enter a location for storing the fingerprint file. Select a location and filename and save the file.

Once a software license has been installed, current versions of the license update utility do not allow you to create another fingerprint without (temporarily) removing the installed software license. Therefore, save the created fingerprint file in case you need to create an additional software license for the same system (this will be the exception because in most cases the existing license can be updated with the required information). If you don't have the fingerprint file anymore and cannot create a second fingerprint because there is already a valid software license installed, please contact your Stromasys representative or VAR. If you have an obsolete/invalid software license on your system, you can remove it as described in Removing a License.

Please note: in older product versions, the hasp_srm_view command cannot be instructed to select a particular key for creating the C2V file. The -key parameter in these versions is only honored when displaying a license, but not for creating a C2V file. The hasp_srm_view command will select one of the available licenses to create a C2V file. This selection cannot be influenced. If you are running a Charon product with this restriction and more than one license is visible to the system, either use Sentinel ACC to create the C2V file for the correct license key or disconnect the other licenses temporarily (this may cause problems for emulators running on the system).