LPT1
- Tim Sneddon (Unlicensed)
Syntax
|
Description to a telnet
The LPT1 object configures the virtual parallel port, it is always present and therefore does not have a load statement.
It is possible to connect the virtual parallel port to either a network port or physical parallel port attached to the host by specifying telnet or device for lpt-device, respectively. If connecting a telnet port, lpt-port can be set to an unused TCP/IP port number. This port number must be prefixed with a colon. For a physical device, specify the parallel port using the syntax, "\.\\LPTn", where n is the controller number.
To control the access mode of the physical parallel port, set the value lpt-mode to either EPP or ECP.
There are some limitations to the parallel port interface and it is intended for non-bidirectional printing.
Related content
© Stromasys, 1999-2024 - All the information is provided on the best effort basis, and might be changed anytime without notice. Information provided does not mean Stromasys commitment to any features described.