AWS Security Groups Overview
A security group can be seen as a virtual firewall that controls the traffic for one or more instances. When you launch an instance, you must assign a security group to the instance. If no custom security group is specified, a default security group will be created and associated with the instance. You can add rules to each security group that allow traffic to or from its associated instances. The rules of a security group can be modified at any time, and the modifications are automatically applied to all instances that are associated with the security group. If there is more than one security group associated with an instance, the rules of all groups are combined.
Security groups in a VPC are associated with network interfaces. Changing an instance's security groups changes the security groups associated with the primary network interface (eth0). Additional security groups can associated with any other network interfaces added to an instance.
Points to note:
- By default, all outbound traffic is allowed.
- Rules in a security group always define what is permitted. They cannot be used to deny specific traffic.
- Response traffic to traffic that was permitted by a rule is always allowed (connection tracking).
Please see the relevant AWS documentation for more information and configuration details.
Connecting to the Cloud Instance
During the configuration of your instance you should have created a security group allowing at the minimum SSH access to the instance. If this has been done correctly, you can, for example, use SSH from the command-line or from a tool such as PuTTY to access the command-line of the user sshuser on the Charon-SSP instance. If you select your instance in the instance list and then click on Connect, you will see the instructions for connecting via SSH.
As shown in the image below, you will see in particular
- the name of the private key that must be used to connect to the instance, and
- the public DNS name of the instance.
The file permissions of the private key file must be set such that the file is only readable by the user as shown in the chmod example above.
There are several ways to connect to your Charon-SSP cloud instance using this basic SSH protocol access. Some of them are described in the following sections below.