...

To add an additional network interface to an instance or to remove an interface from your instance perform the steps described below.

Please note: The steps below only provide a basic overview. The exact tasks required will vary depending on your network design. Please refer to the Oracle cloud documentation for details. In particular, adding additional VNICs to a Linux system running on a baremetal OCI instance requires additional steps to enable the operating system to recognize the additional interface. See https://docs.cloud.oracle.com/iaas/Content/Network/Tasks/managingVNICs.htm for details.

Contents

When an instance is created, a default Ethernet interface is attached to the system. This is the primary network interface You can create additional network interfaces and attach them to an instance. 

Please note: Charon-SSP disables offloading parameters on the Ethernet interfaces it uses. This is required for proper functionality and good performance of the emulator. To allow this configuration to be correctly reflected in the underlying cloud instance NICs for versions before Charon-SSP 4.1.32, the correct networking type (HARDWARE ASSISTED (SR-IOV) NETWORKING) must be chosen when creating the instance. Please refer to Setting up an OCI Instance for Charon-SSP for more information.

Adding a New Network Interface to an Instance

The following steps are required to create a new network interface and to add it to an instance:

...

...

...

Removing a VNIC from an Instance

To remove a VNIC from an instance, select the instance in the instance list and display the Attached VNICs in the Resources section.

Then click on the three dots next to the VNIC and select Delete.

Please note: the primary VNIC cannot be deleted.

...

Address Assignment Information

Each VCN is assigned a block of private IP addresses. This block can be split by the user to form several IP subnets. Routing within one VCN works automatically.

When an OCI instance is launched into a subnet,

• it is automatically assigned a private IP address from the address range assigned to the subnet,
• the user can choose whether to assign a public IP address if the subnet is a public subnet.

Please note: Public IP addresses are not directly visible to the instance. The instance operating system always works with the private address. For external connections, the private address is mapped to the public IP address via NAT.

Reserved addresses (important, if manual address assignment is used):

The following address range is reserved, for example, to allow OCI to query meta-data about instance configuration: 169.254.0.0/16. This range is automatically configured on every network interface.

The following addresses are reserved in each subnet and cannot be used for instance VNICs (shown in the example below for network 10.1.1.0/24):

• 10.1.1.0: the network address
• 10.1.1.1: reserved by OCI for the default router
• 10.1.1.255: network broadcast address.

Other special addresses:

• 169.254.0.0/16: Reserved for OCI use.

Public IP addresses:

There are two types of public IP addresses (only available in public subnets):

• Ephemeral addresses:
  • maximum one per VNIC,
  • assigned by Oracle,
  • persistent during the lifetime of the associated private IP address,
  • can only be associated with the primary private IP address of a VNIC,
  • a user can only delete it but not associate it with a different private IP address.
• Reserved addresses:  
  • maximum 32 per VNIC,
  • created and assigned by the user,
  • can be re-assigned to a different private IP,
  • can be associated with primary and secondary private IP addresses,
  • exists until the user deletes it.

...