Versions Compared

Old Version 9

changes.mady.by.user W.Erber

Saved on

compared with

New Version Current

changes.mady.by.user W.Erber

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Reverted from v. 15

...

Please note: Commands can be entered by typing the full command or the abbreviation indicated by the uppercase letters. The commands can must be entered in lowercase or uppercase letters.

There is an overlap between menus, as shown by the configuration menu (type co or more letters of the command) below:


Important general commands that exist in both menusin the main menu:

CommandDescription

BOOT PRIboot pri

Boot from the primary boot device.
BOOT ALTboot alt
Boot from the alternative boot device.
BOOT boot deviceBoot from device with specified device path. Example device path: 0/0/1/0.0.0
PATH PRIpath priDisplay primary boot path.
PATH ALTpath altDisplay alternative boot path.
PATH path <PRI pri | ALT alt> pathSet the boot path. If neither PRI nor ALT is specified, the primary path will be set.
SEARCHsearchSearch for boot devices
lif path lifimage
Boot a lif file. This parameter is currently mostly used for testing. Use only as advised by Stromasys. The path parameter is a SCSI device path for 64-bit systems, on a 32-bit system it can be the device path of a network card or a SCSI device path. The lifimage parameter contains the path of the bootable lif file (absolute path or path relative to the directory in which the emulator runs).
RESETresetRestart the system.


Div
classpagebreak


Important commands only available in the configuration menu:

CommandDescription
AUTOautoDisplay the autoboot settings.
AUTO BOOT ON | OFFauto boot on | off Enable or disable system autoboot.
BOOTINFObootinfo

Displays a summary of boot parameter and paths as shown below:

DEFAULTdefaultReset the parameter values to the predefined settings.

...

Please note: the service menu and the information menu currently do not contain important additional commands.

Div
classpagebreak


ODE MAPPER2 Program

The MAPPER2 program can be used to report all the emulated hardware of the emulated historic HP3000 or HP9000 PA-RISC system.

To start it, perform the following steps:

  1. Start the Charon instance.
  2. At the PDC menu, enter BOOT PRI to boot pri to boot from the main path.
  3. At the prompt Interact with IPL (Y or N)? >, enter Y.
  4. At the ISL> prompt, enter the command ODE.
  5. At the ODE> prompt, enter RUN MAPPER2.

...

After the program has completed, type exit at the ODE prompt to return to the ISL prompt, or type exit in the hppa Charon-PAR console to stop the emulator.

...