| Anchor | ||||
|---|---|---|---|---|
|
| Include Page | ||||
|---|---|---|---|---|
|
Table of Contents
| Table of Contents | ||
|---|---|---|
|
...
General description
This section describes how to find proper "/dev/sg" device for CHARON mapping
...
Procedures of finding the target "/dev/sg" device
Method 1
Open a terminal console and issue:
|
The output will look something like
If the "lsscsi" command is not installed on your system, use "yum install lsscsi" to make it available. If you cannot install "lsscsi", use method 2 or method 3 described below.
Output example1:
|
Output example2:
|
...
|
| Include Page | ||||
|---|---|---|---|---|
|
| Div | ||
|---|---|---|
| ||
Method 2
Open a terminal console and issue:
# cat /proc/scsi/sg/device_hdr; cat /proc/scsi/sg/devices |
The output will look something likeOutput example:
|
The fifth field column ("type") is the device type.value has the following correspondence:
| Value | Device |
|---|---|
| 0 | Disk |
| 1 | Tape |
| 5 | CD-ROM |
| 8 | Tape changer |
The "N" in the "/dev/sgN" device is the line number in this table (starting from 0) corresponded to the devices CHARON-AXP will use.Thus corresponding to the output provided by the commands above without taking the header into account so here "/dev/sg0" will be corresponds to the the CD-ROM mapping in this example.
| Include Page | ||||
|---|---|---|---|---|
|
...
Method 3
On a freshly booted system, issue the following command:
# dmesg | grep sg |
The output will look like that:
|
This table lists all the devices, not only the real SCSI ones (SATA/IDE for example). CHARON supports only real SCSI devices.
...