Anchor | ||||
---|---|---|---|---|
|
...
<source disk file name> - a file name of the disk image to be transferred
<source disk parameters> - the name of the disk from the list of available on "mkdskcmd --list" request or the disk geometry specification (see below).
- --shrink or -k - used in the case when the target disk is transferred to a smaller disk.
$ mkdskcmd --transfer /etc/rz22.vdisk rz25 |
$ mkdskcmd --transfer <source disk file name> -blsize <number> -blcount <number> |
$ mkdskcmd -t /etc/custom.vdisk -z 512 -c 262134 |
...
Run "hasp_srm_view" utility on the "RecipientHost" with the following parameters to collect the host ID info:
$ hasp_srm_view -idf
The "recipient.id" file will be created in the current directory.
Copy the "recipient.id" file to the "SourceHost".
Info "recipient.id" is an ASCII file, so use the "ascii" option for FTP transfer.
On the "SourceHost", open the "Sentinel Admin Control Center" (ACC) ( http://localhost:1947). Note the number of the software license you are going to transfer.
Run the "hasp_srm_view" utility in the following way to create a transfer license for the host "RecipientHost":
$ hasp_srm_view -tfr <license number> recipient.id
The "license number" is the value collected at the step 3.
Example of collecting a transfer license:
$ hasp_srm_view
-tfr 12345678
recipient.id
A "<license number>.v2c" file will be created in the current directory. In the example above, the name of the transfer license will be "12345678.v2c"
Div class pagebreak Copy the resulting "<license number>.v2c" file to the "RecipientHost".
Info "<license number>.v2c" is an ASCII file, so use the "ascii" option for FTP transfer.
On the "RecipientHost", open "Sentinel Admin Control Center" (ACC) (http://localhost:1947) and apply the "<license number>.v2c" file as described above.
...
The utility allocates chosen network interfaces (both physical and virtual) and configures the offload parameters.
Note |
---|
The NetworkManager service must be running in order to have all the functionalities enabled with "ncu". If the service is not enabled please configure the network using the manual operations described in the section "Manual configuration of CHARON networking" of the Installation chapter of this Guide. |
Dedication of a host physical interface to CHARON
...