...
| Note |
|---|
On Red Hat Enterprise Linux 6 & 7 and CentOS 7, the following packages are needed: bridge-utils - optionaltunctl - optional, need only if command 'ip tuntap' not workedethtool - mandatoryvconfig - optional, if VLAN is needed
On Red Hat Enterprise Linux 8 and CentOS 8, the following packages is needed: |
Using "ncu" utility to establish CHARON virtual network
...
# ncu
CHARON Network Configuration Utility, STROMASYS (c) 20162020 Version 1.6 7
Interfaces Dedicated to State
---------- ------------ -----
eth0 host connected to host
eth1 host disconnected from host
lo host unmanaged from host
=================================================================
bridge name bridge id STP enabled interfaces
========================== VLAN =================================
=================================================================
select action:
1 - Dedicate to CHARON
2 - Release to host
3 - Create Bridge with TAPs
4 - Remove Bridge
5 - Add VLAN
6 - Remove VLAN
7 - Print status
8 - Exit :> 3
|
...
Enter "8" to quit the "ncu" utility.
...
Usage of the virtual interface in CHARON-VAX configuration
Once the “tap<N>” interfaces have been created, the load command maps those interfaces to CHARON-VAX:
...
load tap_port/chnetwrk XQA0 interface="tap<N>"
...
|
| Include Page |
|---|
| KBCOMMON:DOC-GoToToc |
|---|
| KBCOMMON:DOC-GoToToc |
|---|
|