Versions Compared

Old Version 16

changes.mady.by.user W.Erber

Saved on

compared with

New Version 17

changes.mady.by.user W.Erber

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: typo

...

The name of the Ethernet interface in the emulator configuration file has the format EWxn with the following definitions:

  • x is an upercase uppercase letter starting with A for the first interface and then continues with B, C, etc. for additional interfaces. The possible number of network cards depends on the features of the original physical system. The absolute maximum number is 16.
  • n is the device number of the card starting with 0 for each value of x.

...

  • On PA3, use the ISL > ODE > RUN MAPPER2 command (access from console via: Interaction with IPL) to verify the existence of the new interface and the correct device path.
  • The above command also works on PA9, but on HP-UX you can use the lanscan command to verify the existence of the new interface (on HP-UX it is normally lan1).
  • Configure the interface.
    • The easiest way on HP-UX is to use SAM > Network and Communication > Network Interface Cards (Actions > Configure).
    • On MPE/iX, the interface must be added via NMMGR (for interactive use, xhpterm can be used to access this tool), and the interface must be started using the NETCONTROL command. Please refer to the documenation documentation of your operating system for further information.

...