| Anchor | ||||
|---|---|---|---|---|
|
| Include Page | ||||
|---|---|---|---|---|
|
...
| Table of Contents | ||||
|---|---|---|---|---|
|
All Linux and HP-UX sample commands in this section are performed as the root user (prompt = #). This may not be necessary for all commands in all environments depending on the local permission settings. The commands can be executed on the Charon host graphical console or via a non-graphical login (e.g., SSH). However, for accessing the running emulator, the use of PuTTY is strongly recommended because it works best with the emulator environment.
The Charon-PA9 functionality of Charon-PAR emulates the historic HP9000 hardware.
HP-UX ISO Installation Medium
...
HP-UX 9.07 Installation Phase 1: Installing the Basic System
During this phase, a basic system is installed to the root disk that will enable the installation of the rest of the operating system.
After booting the install ISO file as described above, you will eventually see an overview of the installation steps:
After you've read the information, press any key to continue with the next step: the root disk selection.
The following image shows a sample:
In the above sample, select the offered disk by entering its number and press Return.
| Div | ||
|---|---|---|
| ||
Before the installation starts, you have to select if the root disk should support long file names:
You will be offered additional installation options as shown in the sample below:
| Div | ||
|---|---|---|
| ||
Then you are asked to configure the swap space for the system:
...
A set of questions and dialogs will lead you through this step. Note that HP-UX 9.07 may not allow you to set the current year (last year to set may be 1999). You can set the date later using the date command:
# date [-u] [mmddhhmm[[cc]yy]]
(Format: month / day of month / hour / minutes / century / year)
| Div | ||
|---|---|---|
| ||
Step 3: set the root password.
...
After the above steps have been completed, you will be able to login as the root user and start using the system. At the beginning, you have to select your terminal settings.
| Div | ||
|---|---|---|
| ||
Stopping the Emulator
In order to stop the emulator in an orderly manner, perform the following steps:
...