...
- On PA3, use the
ISL > ODE > RUN MAPPER2
command (access from console via: Interaction with IPL) to verify the existence of the new interface and the correct device path. - The above command also works on PA9, but on HP-UX you can also use the
lanscan
command to verify the existence of the new interface (on HP-UX it is normally lan1). - Configure the interface.
- The easiest way on HP-UX is to the following:
- HP-UX before 11.31: use SAM > Network and Communication > Network Interface Cards (Actions > Configure).
- HP-UX 11.31: use SMH > Networking and Communications-> Network Interfaces Configuration > Network Interface Cards.
- On MPE/iX, the interface must be added via NMMGR (for interactive use, xhpterm can be used to access this tool), and the interface must be started using the NETCONTROL command. Please refer to the documentation of your operating system for further information.
- The easiest way on HP-UX is to the following:
...