...
Load network adapter (if required)
If you are configuring a DEQNA, DESQA, DELQA, DEUNA, DELUA, DEMNA, DEBNI or PMADAA adapter, use the "load" command as shown below. CHARON-VAX 3100/96/98 and 4000/106/108 emulations automatically load SGEC (with the name "eza") and therefore no "load" command is required.
Example:load DELQA/DEQNA NICLoad "packet_port" or "tap_port"
Load "packet_port" or "tap_port" to connect the SGEC, DEQNA, DESQA, DELQA, DEUNA, DELUA, DEMNA, DEBNI or PMADAA adapter to the host hardware network card (or to a virtual network interface).
Example:load packet_port/chnetwrk NDIS interface = "eth0"Connect the loaded "packet_port" ("tap_port") to the loaded virtual network adapter
Connect the SGEC, DEQNA, DESQA, DELQA, DEUNA, DELUA, DEMNA, DEBNI or PMADAA adapter to the "packet_port" ("tap_port") by setting the interface name.
Example:set NIC interface = NDIS
...
| Parameter | rx_fifo_size |
|---|---|
| Type | Numeric |
| Value | "rx_fifo_size" sets the receive FIFO size. The value is specified in Kb and by default is pre-calculated from the connected port’s size of receive queue. Typically, you do not need to change the "rx_fifo_size" parameter. It is available for extended tuning and bug hunting purposes. |
| Div | ||
|---|---|---|
| ||
|
Example:
|
...
Example:
load DEMNA/DEMNA EXA |
DEMNA Ethernet Ethernet controller offers the following configuration parameters that can be specified with "set" commandcommand:
xmi_node_id
| Parameter | xmi_node_id |
|---|---|
| Type | Number |
| Value | Specifies the XMI slot in which the virtual DEMNA controller is placed. For CHARON-VAX/66X0 a free slot between 10 (A) and 14 (E) must be chosen. |
...
| Info |
|---|
"tap_port" parameters are the same as "packet_port" ones |
Example:
|
| Div | ||
|---|---|---|
| ||
|
Supported Ethernet Q-bus Adapters for DECnet OSI (DECnet Plus)
...