| Anchor | ||||
|---|---|---|---|---|
|
| Include Page | ||||
|---|---|---|---|---|
|
...
| Status | ||||
|---|---|---|---|---|
|
The default setting is:
load virtual_serial_line/chserial OPA0 port=10003 application="putty.exe -load OPA0" |
The second console line "TTA0" can be also optionally configured (for 1 CPU models such as HP AlphaServer 400, HP AlphaServer 800, HP AlphaServer 1000, HP AlphaServer 1000A, HP AlphaServer DS10, HP AlphaServer DS10L and HP AlphaServer DS15):
|
Note there are a number of Note that additional parameters for the CHARON VM serial lines configuration can be added. Follow this link for details.
...
Exit on pressing F6 button
Despite the fact that the CHARON VM can exit stop with the "power off" command given in its entered at SRM console level, it is also recommended to set a hot key to stop the guest VM from the console in addition to the system tray icon(when the console is accessed remotely for example):
set OPA0 stop_on = F6 |
This line allow allows the CHARON VM to be stopped by pressing the "F6" buttonkey.
...
Do not uncomment this parameter unless there are some problems with the system time or the system clock intervals in the guest OS.
...
Disk/tape subsystem
The next step is the configuration of the disk/tape subsystem and mapping it to system resources disk and tapes subsystems and the mapping to the system resources can be done using the samples given in the template configuration files.
...
Below is the typical configuration options for the KZPBA PCI SCSI disk/tape controller:
...
Follow this link for details on the KZPBA controllers configuration.
Back to Table of Contents
KGPSA-CA PCI FC disk controller
...
Follow this link for details on the KGPSA-CA controllers configuration.
Back to Table of Contents
KGPSA-CA mapping to the host resources
...
The numbers in the square brackets represent the KGPSA-CA units. They can be in the range of 0 to 32766 but no more than 255 units can be configured on a single controller.
Back to Table of Contents
KGPSA-CA mapping to a storage controller using its "presentation" mode
...
| Type of mapping | Description |
|---|---|
| storage_controller_path_id = <Storage controller path ID> | "Storage controller path ID" is a storage (for example SAN) controller path ID. This ID can be obtained from the special utility "Device check tool" (accessible in the "Host Information and Utilities" section of the CHARON Virtual Machines Manager). Once specified, all the disks attached to the storage are automatically mapped as disk units to the CHARON VM. |
Back to Table of Contents
KGPSA-CA pass through mode
...
| Supported | Not Supported | Not tested |
|---|---|---|
LP8000 | LPe1150 (FC2142SR, A8002A) | LPe11000 |
Back to Table of Contents
| Div | ||
|---|---|---|
| ||
FDDI support via DEFPA PCI FDDI controller in "pass through" mode
...
Non-US-EN installations of Windows may present “Location:” string in local language, but "host_bus_location" parameter requires English notation, so the words “PCI”, “bus”, “device”, and “function” must be specified in English.
Back to Table of Contents
| Div | ||
|---|---|---|
| ||
Serial lines support via emulated PBXDA-xx family PCI controllers in "pass through" mode
...