| Include Page |
|---|
| KBCOMMON:KB-CSSstyle |
|---|
| KBCOMMON:KB-CSSstyle |
|---|
|
...
They can be configured in 3 modes:
Below is an example of a KGPSA-CA controller loading:
...
Follow this link for details on the KGPSA-CA controllers configuration.
| Include Page |
|---|
| KBCOMMON:DOC-GoToToc |
|---|
| KBCOMMON:DOC-GoToToc |
|---|
|
KGPSA-CA mapping to the host resourcesBelow is the typical configuration options for a KGPSA-CA PCI FC disk controller, mapped to the host resources:
...
| Include Page |
|---|
| KBCOMMON:DOC-GoToToc |
|---|
| KBCOMMON:DOC-GoToToc |
|---|
|
KGPSA-CA mapping to a storage controller using its "presentation" modeSome storage controllers allows CHARON VM to use their resources using so called "presentation" mode.
...
| Include Page |
|---|
| KBCOMMON:DOC-GoToToc |
|---|
| KBCOMMON:DOC-GoToToc |
|---|
|
KGPSA-CA pass through modeIt is also possible to use the emulated KGPSA-CA in "pass through" mode to address a physical EMULEX LightPulse PCI/PCI-X/PCIe FC adapter plugged into the host’s PCI/PCI-X/PCIe slot.
...
Optionally it is possible to configure the folIowing models of PBXDA-xx family controllers.
VIrtual PBXDA-xx
Syntax for loading PBXDA-xx family serial lines adapters:
#load PBXDA/DIGI <name>
#load PBXDA_BA/DIGI <name>
#load PBXDA_BB/DIGI <name>
#load PBXDA_AC/DIGI <name>
|
Example:
The adapter instance name ("TXA" in the example above) is used then for parametrization, for example:
set TXA line[2]="COM1:"
set TXA port[3]=1706
|
The numbers in the square brackets represent line number on the virtual PBXDA adapter starting from 0.
...