| Anchor | ||||
|---|---|---|---|---|
|
...
| Warning |
|---|
Installation of Sentinel run-time (driver) described below is needed for Sentinel HASP keys (both regular and network), Sentinel HL keys (both regular and network) without "driverless" mode enabled, Sentinel HL Network keys (red dongles) - is if they are going to be used network wide - and Sentinel Software Licenses (SL). Please skip installation of Sentinel run-time (driver) if you use locally connected Sentinel HL keys in "driverless" mode or going to use Sentinel HL Network key in "driverless" mode from some other host on local network. Just connect the license key to the host and proceed with collecting "*.c2v" file (see below) if the license inside your Sentinel HL key must be updated. |
...
Disable remote keys access A helpful feature of Sentinel Admin Control Center is the ability to disable access to remote keys. If the network key is installed locally, access to the key from remote hosts can be disabled. The following examples demonstrate how this can be done.
To disable access to remote keys switch to the "Access to Remote License Managers" tab and uncheck the "Allow Access to Remote Licenses" checkbox. Then press the "Submit" button to apply this change:
To disable access to the locally installed license key from remote hosts switch to the "Access from Remote Clients" tab and uncheck the "Allow Access from Remote Clients" checkbox. Then press "Submit" button to apply this setting:
Back to Table of Contents
...