| Anchor | ||||
|---|---|---|---|---|
|
| Include Page | ||||
|---|---|---|---|---|
|
...
CHARON-VAX model | Minimal number of CPU cores | Recommended number of CPU cores |
|---|---|---|
VAX 6610 | 2 | 4 |
VAX 6620 | 3 | 4 |
VAX 6630 | 4 | 6 |
VAX 6640 | 6 | 8 |
VAX 6650 | 8 | 12 |
VAX 6660 | 8 | 12 |
| Other models | 2 | 2 |
When starting, the CHARON-VAX software checks the available number of host CPU cores. Currently, this check is based on the maximum number of VAX CPUs that can be emulated, not on the number of the actually configured VAX CPUs. Therefore the number of host CPU cores recommended for the maximum number of emulated CPUs - as shown in the right column of the table above - must be available. If the available number of host CPU cores is below this number, CHARON-VAX will issue a warning message even if the requirements for the configured number of VAX CPUs are fulfilled. The CHARON-VAX software will work despite this warning if the requirements for the configured number of VAX CPUs are fulfilled.
| Note |
|---|
Hyper-threading must be switched off completely. Disable hyper-threading in the BIOS settings of the physical host or, for a VMware virtual machine, edit the virtual machine properties, select the Resources tab then select Advanced CPU. Set the Hyper-threaded Core Sharing mode to None. |
...
| Note |
|---|
For VMware based CHARON hosts, it is mandatory to use "E1000" virtual network adapters. "E1000E" adapters are not supported. |
| Info |
|---|
Starting with ESXi 6.5, it is not possible to select E1000 adapter when a new virtual machine is created using Windows Server 2012 and 2016 templates. The following workarounds are avaible:
|
| Include Page | ||||
|---|---|---|---|---|
|
...