...
Login a root. Start "ncu" utility:
# ncu
CHARON Network Configuration Utility, STROMASYS (c) 2016 Version 1.6
Interfaces Dedicated to State
---------- ------------ ------------
eth0 host connected to host
eth1 host connected to host
lo host unmanaged from host
=================================================================
bridge name bridge id STP enabled interfaces
========================== VLAN =================================
================================================================= select action:
1 - Dedicate to CHARON
2 - Release to host
3 - Create Bridge with TAPs
4 - Remove Bridge
5 - Add VLAN
6 - Remove VLAN
7 - Print status
8 - Exit :> 5
|
Enter "5" then enter:
- The phisical interface name to be used for creating VLAN
- The ID of the VLAN device
- IP address of the VLAN device. Skip this step if no IP is required
- Network mask of the VLAN device. Enter for no network mask.
Specify the phys interface used for VLAN:eth1
Specify the id of VLAN device (<4095):111
Specify the ip address of VLAN device or empty string for no ip address: 192.168.1.100
Specify the netmask address of VLAN device or empty string for no netmask: 225.225.225.0 select action:
1 - Dedicate to CHARON
2 - Release to host
3 - Create Bridge with TAPs
4 - Remove Bridge
5 - Add VLAN
6 - Remove VLAN
7 - Print status
8 - Exit :> 8
|
Enter "8" to quit "ncu" utility.
Back to Table of Contents
Removing VLAN interface
Login a root. Start "ncu" utility:
# ncu
CHARON Network Configuration Utility, STROMASYS (c) 2016 Version 1.6
Interfaces Dedicated to State
---------- ------------ ------------
eth0 host connected to host
eth1 host connected to host
lo host unmanaged from host
=================================================================
bridge name bridge id STP enabled interfaces ========================== VLAN =================================
eth1.111
================================================================= select action:
1 - Dedicate to CHARON
2 - Release to host
3 - Create Bridge with TAPs
4 - Remove Bridge
5 - Add VLAN
6 - Remove VLAN
7 - Print status
8 - Exit :> 6
|
Enter "6" then enter the VLAN interface for remove:
Specify the VLAN interface, which be removed: eth1.111
Removed VLAN -:eth1.111:-select action:
1 - Dedicate to CHARON
2 - Release to host
3 - Create Bridge with TAPs
4 - Remove Bridge
5 - Add VLAN
6 - Remove VLAN
7 - Print status
8 - Exit :> 8
|
Enter "8" to quit "ncu" utility.
Back to Table of Contents