...
The "Network Control Center" utility is used to configure, verify dedicated network interfaces and trace network trace the network activity for a CHARON network.
Open the CHARON Virtual Machines Manager, switch to the "Host Information & Utilities" tab and press the "Network Control Center" button:
...
| Div | ||
|---|---|---|
| ||
Browse for the target "sripacket.inf" file (which is by default it is located in the "C:\Program Files\CHARON\Drivers\NDIS6_X.X.X.XXXXX" directory), select it and press the "Open" button:
...
If the CHARON network driver has been acquired directly from STROMASYS, put it in a temporary directory and choose the "sripacket.inf" file from this directory in the dialog above.
...
Review the log, make sure it is correct. Save You can save the log to a file by pressing the "Save Log in file" button in case the log file has to be sent to Stromasys Customer Support.
...
Review the log for errors. Save You can save the log to a file by pressing the "Save Log in file" button in case the log file has to be sent to Stromasys Customer Support.
...
Configuring the host network interfaces for CHARON
Start the utility and , select "Configure NIC" ; and press the "Next" button:
| Div | ||
|---|---|---|
| ||
...
Review the log for errors. Save You can save the log to a file by pressing the "Save Log in file" button in case the log file has to be sent to Stromasys Customer Support.
...
Release of the host network interfaces
Start the utility and , select "Configure NIC" ; press and press the "Next" button:
| Div | ||
|---|---|---|
| ||
...
Troubleshooting the CHARON network interfaces configuration
Start the utility and , select "Troubleshoot NIC dedicated for CHARON" ; and press the "Next" button:
| Div | ||
|---|---|---|
| ||
...
| Div | ||
|---|---|---|
| ||
The utility will fix any fix issues and report a good status for the interface. Press the "Next" button, the following dialog will appear:
...
| Div | ||
|---|---|---|
| ||
Once the checking check is completed, if there are any issues, the utility will abort the test and display a log containing information about the issues found:
...
Enter the IP address and subnet mask to be used by the CHARON guest , then press the "Next" button:
...
The Network Control Center is able to disable "offload" parameters for CHARON. It is highly recommended to disable them to avoid any problems with TCP/IP networking under CHARON.
Start the utility and , select "Disable TCP chimney offload for CHARON" ; and press the "Next" button:
The "offload" parameters will be reset for all CHARON emulators (executable files).
...
| Info |
|---|
More information on details of disabling TCP chimney offload is available in this article from the knowledge base. |
...
Select the network interface to monitor (it must be dedicated to CHARON) ; and press the "Next" button:
| Div | ||
|---|---|---|
| ||
...