...
| Step | Command / Action | |
|---|---|---|
| 1 | Make sure the pre-configured preconfigured PuTTY profiles are in the directory .putty/sessions or .config/putty/sessions in your home directory. | (see Charon-HPA Software Installation) |
| 2 | Start PuTTY from the command-line. |
|
| 3 | Should you get an error that a font was not found, change the font. | Start PuTTY from the command-line.
Select and load the required profile. |
| 4 | To connect from a remote host, change localhost in the template to the correct hostname or IP address. | Start PuTTY from the command-line.
Select and load the required profile. |
...
| Step | Command / Action | |
|---|---|---|
| 1 | Make sure the pre-configured preconfigured PuTTY profiles are in the directory .putty/sessions or .config/putty/sessions in your home directory. | (see Charon-HPA Software Installation) |
| 2 | Start PuTTY from the command-line. | $ putty -load HPA-Telnet-VT100 |
| 3 | Should you get an error that a font was not found, change the font. | Start PuTTY from the command-line.
Select and load the required profile. Select Fonts on the left and select a monospace font. Select Session on the left and save the profile. |
| 4 | To connect from a remote host, change localhost in the template to the correct hostname or IP address. | Start PuTTY from the command-line.
Select and load the required profile. Change the hostname to the one of the Charon-HPA host as required. Connect to the remote Charon-HPA system. |
...