Versions Compared

Old Version 5

changes.mady.by.user W.Erber

Saved on

compared with

New Version 6

changes.mady.by.user W.Erber

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: review comment re. mpe version

...

If you have enough disk space on the Charon-HPA emulated HP3000, you can copy existing HP3000 software, data, and settings to the guest MPE/iX system. Charon-HPA comes with MPE/iX
7.5 already installed and patched. So you avoid the most difficult part of setting up a new system.

Warning

Charon-HPA comes with MPE/iX 7.5 - it will not work with there are significant restrictions for earlier MPE/iX releases. You Charon-HPA may not run with such releases. When using the provided system disk, you must not overwrite any MPE files with copies from earlier MPE releases. As a general rule, specify the ;KEEP keyword on :RESTORE commands, especially when using STORE tapes that may contain PUB.SYS files. It is strongly recommended to use the MPE/iX 7.5 disk provided by Stromasys. Should you have different requirements, please discuss them with your Stromasys representative.


Note

This section only describes general methods for file transfer. The specific data transfer required to migrate a physical system to an emulated system (e.g. copying the account structure) is not covered by the user's guide. To obtain support for system migration, contact your Stromasys representative or Stromasys partner.

...